Instructions for the Crafts&Co Embossing label puncher
Instructions for the Crafts&Co Embossing label puncher
We are always there for you
Do you have a question about one of our products or about your order? Our team is ready to answer all your questions.
Our customer service is available from Monday to Friday between 09:00 and 17:30
Frequently asked questions
- Q: Where can I buy refill paper for the label puncher?
A: You can only buy refill paper for the label puncher at Action stores.
- Q: What do I do if the label gets stuck in the label puncher?
A: Open the Label Punch Maker by pulling the cover on the handle forward. Remove the roll and reinsert it into the device. Click a dot or comma a few times to make sure the ribbon is picked up properly. Now it is working properly again!
- Q: Is the embossing label puncher available on more than one colour?
A: No, at the moment the embossing label maker is available in one colour; blue.
- Q: Why is the first letter cut off of the label?
A: Each time you cut the label, it gets cut very short. Therefore it is important to always start each label by clicking space 1 or 2 times.
- Q: Why is my label not feeding through the label maker?
A: After cutting your previous label, the label maker could have some difficulties grabbing onto the remaing label roll. You can solve this by opening the roll compartment, and pushing the label through the correct slot whilst clicking the handle.
- Q: Why are my letters not bright and clear?
A: The letters can look faded or hard to read if you do not click the handle forcefully enough. Make sure you click and hold for a second to get the most clear results.
- Q: I cannot click the handle on the label maker. What do I do?
A: Make sure that you align the alphabet wheel correctly. Misalignment blocks the handle.
Latest blogs
Customers rate us 8,8!
"I like to build the miniatures. Its really creative. I can buy the Kits in my local store and its ch..."
Brigitta Sarvari - 05-11-2026
"Goed: er was onverwacht iets mis met een product, maar mijn vraag daarover werd snel en adequaat afg..."
Studio Gagarin - 03-11-2026